Twin Rod Bell

Twin Rod Bell

Baltimore (tug)

I want to introduct something about 950cc Engine. Terms of Payment: L/C,T/T Engine: 936cc, 4-stroke, DOHC 4, liquid cooled, 60V - twin Compression ratio: 10: 1 Power output: 62.5kW (6,000r/ min), 104nm at 4,000rpm Engine lubrication: wet sump, double filter, pressure pump, cams and gear box Clutch: multi disc in oil bath Transmission: 6 speed gear box This state-of-the-art, fuel injected, eight valve, DOHC, six speed V-twin develops 80-100 Hp depending on tuning and offers full response and power even at low revs. Engine:936cc, 4-stroke, DOHC 4, liquid cooled, 60V - twin Compression ratio:10: 1 Power output:62.5kW (6,000r/ min), 104nm at 4,000rpm Engine lubrication:wet sump, double filter, pressure pump, cams and gear box Clutch:multi disc in oil bath Transmission:6 speed gear box
BALTIMORE (tug)
U.S. National Register of Historic Places
U.S. National Historic Landmark

Location:
Baltimore, Maryland
Coordinates:
3916?28?N 7636?1?W? / ?39.27444 76.60028? / 39.27444; -76.60028
Built/Founded:
1906
Architect:
Skinner Shipbuilding
Governing body:
Private
Added to NRHP:
November 04, 1993
Designated NHL:
November 04, 1993
NRHPReference#:
93001613
The Baltimore is a preserved steam-powered tugboat, built in 1906 by the Skinner Shipbuilding Company of Baltimore, Maryland. It is the oldest operating steam tugboat in the United States. The Baltimore was built and operated as a harbor inspection tug, capable of acting as a municipal tugboat for city barges, as well as an official welcoming vessel and VIP launch, an auxiliary fireboat, and as a light icebreaker.
It was declared a National Historic Landmark in 1993.
Description
The Baltimore is equipped with a compound reciprocating steam engine, fed by a scotch marine boiler. Hull construction is rivetted iron, with a wood deckhouse. The 84.5feet (25.8m) wrought iron hull has proven to be more durable than steel or wood. Displacement measures 81 gross tons and 55 net tons. The hull form is typical for its time, with an upright stem, moderate sheer and elliptical stern. Bulwarks are vertical about the stern rather than inwardly-sloped as in more modern designs.
Boiler
The boiler was a replacement for the original, fitted in 1922, but is similar to the original. The cylindrical boiler measures 9.5feet (2.9m) by 10.25feet (3.12m), with two Morrison furnaces connecting to a combustion chamber at the rear. Fire tubes pass from the back to the front of the boiler. Exhaust passes through an annular steam dryer/superheater on its way to the smokestack. Originally design to burn coal, the boiler was converted to oil in 1957. The boiler has since been converted back to coal by the Museum of Industry, including the restoration of the original coal bunkers. Steam pressure as designed was 150psi, however it is limited to 115psi by the boiler rating.
Engine
The tug is powered by a compound double-acting, vertical-inverted steam reciprocating engine, a common type for tugboats. A 12inches (30cm) high-pressure cylinder operates at 150psi (now 115psi), while a 25inches (64cm) low-pressure cylinder takes the high-pressure cylinder's exhaust at 17psi. Both cylinders have a stroke of 22inches (56cm), offset by 90 degrees to keep the engine from being stuck on center. A manual jacking gear acts as a further measure to prevent sticking on center. Stephenson valve gear permits reversing, aided by a steam reversing engine or ram to adjust eccentric rods. The propellor has a diameter of 6.75feet (2.06m) with a pitch of 8.66feet (2.64m).
Auxiliaries and pumps
The Baltimore has a rotative duplex donkey pump, duplex feed pump, duplex sanitary pump and a centrifugal circulating pump. The pump system provides a moderate fire fighting capability through two hose standpipes on top of the pilothouse. Piping runs to each compartment allow water to be forced out through air pressure in the event of flooding.
A 5.5 KW Westinghouse dynamo provides electrical power, driven by an American Blocwer steam engine at 500 RPM. A Pyle National 5 KW reserve generator was installed in 1957. The electrical system was unusual in 1906, and was fitted when the yard was able to build the tug for substantially less than the estimated cost.
Superstructure
The full-length deckhouse is built of Georgia pine, with a similarly-constructed pilothouse on top, set slightly back from the front of the deckhouse. Both are sheathed with tongue-and-groove planking. Windows are sash units designed to drop into self-draining metal pockets in the bulkheads. A saloon fills the front of the deckhouse, finished with oak match board. Aft of a bulkhead a companionway ladder leads to the pilothouse. The middle of the deckhouse covers the boiler and engine room spaces. The rear of the deckhouse contains the galley, provided with a Shipmate oal-burning stove. The deckhouse ends at toilets, officers to port and crew to starboard.
The pilothouse has an elliptical forward face and a flat rear. A steam radiator provides heat, and a ladder provides access to the pilothouse roof. The large wheel dominates the house, its size dictated by the entirely manual steering gear, an anachronistic feature for the time. Voice pipes run to the engine room and saloon. Bells provide additional communication to the engine room. Whistles are fitted for signals to ships and shore.
A 20feet (6.1m) Kallenweller...(and so on) To get More information , you can visit some products about slat conveyor, Industrial Wall Fan, . The 950cc Engine products should be show more here!

About the Author

himfr can provide you most popular hot products from china!

Twin Rod Bell

Tagged with: twin rod bell

Filed under: Fishing Rods